Tim Willey

Sculpture - Conservation - Education

Stacks Image 3

Progressive Open-Firing Mk2
Below I’ve illustrated a simplified design of the firing grate (Mk2). It’s no more efficient than the round version but it is much easier to fabricate. This particular grate will be used for test firings so it’s quite small (35 x 35cm) with 15cm legs. I start with a welded square made up from 10mm mild steel bar and then weld in 5 rods evenly spaced (6cm centres giving a 5cm gap) and finally weld in the 15cm legs. I guess I could probably extend the area to 45cm square, using the same gauge of round steel bar and retaining the 15cm legs, but it does get very hot (approx.900c) so sagging could be an issue. For this firing I have used waste timber (bone-dry fencing stakes and thin fencing-panel boards).
Stacks Image 58
A fire is started on the grate using bone-dry timber.
Stacks Image 15
Embers from the subsided fire are encouraged to fall under the grate. To arrange the embers I use an old garden hoe which has a dampened wooden handle to avoid scorching.
Stacks Image 79
When the embers have died down till barely alive, the test pieces are placed on the grate. This is a critical time as some clay bodies might spall or explode if too hot.
Stacks Image 19
The fire is very slowly re-kindled with wood shavings and fine slivers of wood. This stage took about an hour, but it could be slowed down to suit the clay. Also, I’m careful to arrange the embers - spreading them out to quell the fire or building them up to re-ignite. Caution is needed at this critical stage. Again I use the hoe.
Stacks Image 24
When satisfied that the pots are well over 200c the under-fire is built up, using slightly more substantial slivers of wood.
Stacks Image 28
Slivers of wood are then slotted into the grate, from the perimeter to the centre.
Stacks Image 76
Wood is added to the top of the grate.
Stacks Image 32
Finally, 60cm lengths of fencing board is added to the fire carefully but quickly. The first boards will touch the pots so extra caution is needed to avoid breakages.
Stacks Image 67
The fire rages and, as seen here, the grate begins to glow orange/red. This is a good sign that the pots have reached temperature (800 - 900c).
Stacks Image 70
The fire subsides and the pots cool. This is the stage when cooling dunts might occur, so I’m listening out for suspicious sounds!
Stacks Image 73
The final tests have survived. One tempered with crushed oyster shells and the other with grog.
This very cautious, progressive open-firing, is useful for testing clays of unknown firing-behaviour or clays with modest amounts of tempering (the grogged test -piece, only contains 25% which is quite low for an open firing).

The firing grate has been very effective - it gets heat under the pots, it allows for well regulated pre-heating, and, as any blacksmith knows, the change of the metal’s colour is useful for gauging temperature. Also, it prevents the ware from sinking into a bed of ashes, which at the early stages of firing insulates the pots from the heat above.

The progressive open-firing, I think proves, that if taken slow enough, many clays can be open-fired successfully.

Note: Open-firing is dangerous, so I always wear PPE appropriate for hot working.